Installing A Panel Pc With An Ap9X3 Panel - B&R PC 3100 User Manual

Installation and wiring
Information about the device's environment
• Observe the notes and regulations regarding the power supply and functional ground.
• Observer the specified bend radius when connecting cables.
• Ventilation openings are not permitted to be covered or blocked.
• The device is only permitted to be operated in closed rooms and not permitted to be exposed to direct
sunlight.
• The climatic ambient conditions and environmental conditions must be taken into account –
mental properties" on page
General installation instructions
• When installing the device, the permissible mounting orientations must be observed -
entations" on page
• When connecting installed or connected peripherals, follow the instructions in the peripheral device's doc-
umentation.
Transport and storage
Condensation may form under certain environmental conditions or rapid climatic changes. For im-
proved acclimatization and to avoid damage, the device must be slowly adapted to the room temper-
ature.
When transporting at low temperatures or in the event of large temperature fluctuations, the collection of moisture
in or on the device is not permitted. Moisture can cause short circuits in electrical circuits and damage the device.
If a device is transported or stored without packaging, all environmental influences such as shocks, vibrations,
pressure and moisture have an unprotected effect on the device. Damaged packaging indicates that the device
has been severely affected by environmental influences and may have been damaged.
This can result in malfunctions of the device, machine or system.
Use of third-party products
If third-party devices or components are used, the relevant manufacturer's documentation must be observed. If lim-
itations or interactions by or with third-party products are possible, this must be taken into account in the application.

5.1.1 Installing a Panel PC with an AP9x3 panel

The Panel PC 3100 with AP9x3 panel is installed in the installation cutout using retaining clips. The number of
retaining clips depends on the panel.
The device must be installed on a flat, clean and burr-free surface since tightening screws on an uneven area can
result in damage to the display or the ingress of dust and water.
Required tools:
• 2.5 mm hex screwdriver
Notice!
All the included retaining clips and clamping blocks must be used during installation. Failure to do
so can result in damage to property due to loss of leak tightness between the device and housing
(pollution) or mechanical stress.
208
38.
36.
The following AP9x3 panels are installed with retaining
clips:
• 5AP923.1215-00
• 5AP923.1505-00
• 5AP923.1906-00
Panel PC 3100 panel mount device User's manual V 2.10
see "Environ-
see "Mounting ori-
• 5AP933.156B-00
• 5AP933.185B-00
• 5AP933.215C-00
• 5AP933.240C-00