4. Secure the retaining clips by alternately tightening the mounting screws with a 2.5 mm hex screwdriver (max.
tightening torque 1 Nm).
Thickness of the wall or control cabinet
W
5.1.3 Installing the Automation Panel 1000 with clamping blocks
The Panel PC 3100 with AP1000 panel is installed in the installation cutout using clamping blocks. The number
of clamping blocks depends on the panel.
The device must be installed on a flat, clean and burr-free surface since tightening screws on an uneven area can
result in damage to the display or the ingress of dust and water.
Required tools:
• 3.0 mm hex screwdriver
Notice!
All the included retaining clips and clamping blocks must be used during installation. Failure to do
so can result in damage to property due to loss of leak tightness between the device and housing
(pollution) or mechanical stress.
Panel PC 3100 panel mount device User's manual V 2.10
Minimum
See
"Installation diagrams" on page 32
The following AP1000 panels are installed with clamp-
ing blocks:
• 5AP118x.1043-000
• 5AP1120.1214-000
• 5AP1120.1505-000
• 5AP118x.1505-000
• 5AP1120.1906-000
Installation and wiring
Maximum
211