Information About This Document; Organization Of Safety Notices; Guidelines - B&R PC 3100 User Manual

1.2 Information about this document

This document is not intended for end customers! The safety guidelines required for end customers
must be incorporated into the operating instructions for end customers in the respective national lan-
guage by the machine manufacturer or system provider.

1.2.1 Organization of safety notices

Safety notices in this manual are organized as follows:
Safety notice
Danger!
Warning!
Caution!
Information:

1.2.2 Guidelines

European dimension standards apply to all dimension diagrams.
All dimensions in millimeters.
Unless otherwise specified, the following general tolerances apply:
Nominal dimension range
Up to 6 mm
Over 6 to 30 mm
Over 30 to 120 mm
Over 120 to 400 mm
Over 400 to 1000 mm
Table 2: Nominal dimension ranges
Panel PC 3100 panel mount device User's manual V 2.10
Description
Failure to observe these safety guidelines and notices can result in death, severe injury or substantial damage to property.
Failure to observe these safety guidelines and notices can result in severe injury or substantial damage to property.
Failure to observe these safety guidelines and notices can result in injury or damage to property.
These instructions are important for avoiding malfunctions.
Table 1: Description of the safety notices used in this documentation
General tolerance per
DIN ISO 2768 medium
±0.1 mm
±0.2 mm
±0.3 mm
±0.5 mm
±0.8 mm
Introduction
11