Connecting The Interface Cable - Genicom 4810 User Manual

Connecting the Interface Cable
Nov 93
Both a 25-pin RS-232C serial and a 36-pin CENTRONICS parallel interface
connector are standard on this printer. Both connectors are located on the
data connector plate on the rear of the printer. See Figure 1-7.
Chapter 4 contains useful information for setting up the interface to match
your host. Any necessary changes in the setup are made by changing strap
options through the control panel. Appendix F lists the interface strapping
options.
The circuitry for Dataproducts short line parallel interface is resident in the
printer. A different data connector plate with the proper connector is normal-
ly required to use the short line interface and is available as an option.
Options available:
• Dataproducts short line (data connector plate, connector, and internal
cable and connector)
• Dataproducts long line (circuit board, internal cable, and connector)
Both options are available with either a 50-pin Winchester or 50-pin D-type
connector. See Appendix D for a complete list of options.
25-PIN
SERIAL
CONNECTOR ---..u1ii
Ii
1:
Interface Cable Connector
Figure 1-7
Chapter I. Gening the Printer Up and Running 1-
7