Table of Contents
Advertisement
Chapter 4. Printer Interface
Introduction
Nov93
These printers are configured with both CENTRONICS parallel and RS-232C
serial interfaces. The 36-pin parallel and 25-pin serial interface connectors
are located at the rear of the printer cabinet. See Figure 4-1.
Both interfaces can be monitored for data by selecting the multisource
option from the control panel.
The circuitry for Dataproducts short line parallel interface is resident in the
printer. A different data connector plate with the proper connector is
normally required to use the short line interface and is available as an
option.
Options available:
• Dataproducts short line (data connector plate with connector and
internal cable).
• Dataproducts long line (circuit board, data connector plate with
connector and internal cable).
Both options are available with either a 50-pin Winchester or 50-pin D-type
connector. See Appendix D for a complete list of options.
Interface Connectors
Figure 4-1
Olap<<r 4.
Prinlor ln1orf1«
4- l
Advertisement
Table of Contents
