Using The Program Mode - Genicom 4810 User Manual

Using the Program Mode
Enter
While in
Local.
Press
4(Program]
to enter the Program Mode.
Starting with this page. the displays shown on the far left side are first-level menu
choices. Press the ENTER pushbutton to cause the printer to perform that operation
or to enter into a second-level menu. Second-level and subsequent sub-menus are
shown indented under their parent menus.
Press the NEXT OPTION (0) or PREVIOUS OPTION
(1)
pushbutton to change the
display to the next menu item.
Press QUIT (2) to return to the parent menu or to
Local
when in a first-level menu.
Press EXIT (3) to leave the Program Mode and return to
Local.
NOTE:
The first menu discussed in this section is for selecting the emulation. The
emulation
must be selected first to enable the proper menu displays to appear. Press
the NEXT OPTION (OJ pushbutton Wlttl PRG:Emulation
appears in the display.
PRG:Emulation
This menu is used to select the emulation. This printer can
emulate (become functionally similar to) ANSI Standard X3. 64-1979.
Printronix P-Series, IBM Proprinter. Dataproducts, and Epson
FX-286 type protocols. From this point on, these protocols will be
referred to as ANSI, P Series, Proprinter, Dataproducts, and FX-286
emulations.
2-32
User's Manual
Which emulation to use will depend on what control codes and
escape sequences will be sent by the host. See
Programmer's
ManuaL GEK-89025.
for information on each emulation.
Press the ENTER (4) pushbutton to enter the following sub-menu:
Emul:ANSI
Emul:FX286
Emul:Proprlnter
Emul:Prlntronlx
Emu I: Dataproduct
Press the
NExr
OPTION (0) pushbutton until the desired emulation
appears in the display, and then press the ENTER (4) pushbutton.
When the emulation is selected, the printer will perform a self-test
and the display will show
Self Test
followed by
Loadlng ..... Wait.
All
printer parameters will
be
set to the default state as if an ESC c
had been received from the host.
Nov 9~