Table of Contents
Advertisement
Paper Thickness Adjustment
The paper tension adjustment lever is located next to the p1int gap
adjustment wheel. It is used to maintain the proper tension on the paper
during printing.
Place the five-position lever to LO (the bottom position) when loading paper,
setting top of form, and printing single-part paper. This position applies the
least tension to the paper and should be used as the first trial position for all
forms.
For multipart forms and single-part paper that is heavier than 20 pounds.
higher paper tension lever settings may be required. Six-part forms are
normally run at the second or third position.
AJ94
Paper Thickness Adjustment Lever
Figure
1-18
Chapter I. Getting the Printer Up and Running
1-21
Advertisement
Table of Contents
