Table of Contents
Advertisement
Using the Function Mode
Exit
While in
Local,
Press
3[Func11on)
to enter the Function Mode.
Starting on this page. the displays shown on the far left side are first-level menu
choices. Press the ENTER pushbutton to cause the printer to perform that operation
or to enter into a second-level menu. Second-level and subsequent sub-menus are
shown indented under their parent menus. The horizontal lines are used to show
the beginning and end of a first-level parent menu and all of its sub-menu options.
Press the NEXT OPTION (0) or PREVIOUS OPTION
(1)
pushbutton to change the
display to the next menu item.
Press QUIT (2) to return to the parent menu or to
Local
when in a first-level menu.
Press EXIT (3) to leave the Function Mode and return to
Local.
FCT:Reverse FF
Pressing the ENTER (4) pushbutton causes a reverse form feed to
occur. Use this feature to position the first form at the upper
tractors after moving paper out of the printer to tear off printed
forms. This feature can also
be
used to back paper out of the
printer after the print Job is finished and the printed forms have
been torn off.
Important:
If the paper is inadvertently backed out of the upper
tractors, the paper will have to be reloaded.
FCT:Software ID
Software identification - Used to show the part or version number
of the installed software.
ID:TTLB -
Table Top Logic Board identification.
TTLB:44AXXXXXX -
Part number of currently installed firmware.
ID:TTMI -
Table Top Machine Interface Board identification.
TTMl:Rev XX -
Revision number of circuit board.
Nov 93
Chapter 2, Opera Ung th~ Printer
2-11
Advertisement
Table of Contents
