Table of Contents
Advertisement
13. Close the front access panel and the pedestal enclosure door.
NOTE: After the paper has been loaded, the print gap, paper tension, paper
path, and top of form position must be set. These settings are discussed later
is this chapter after the installation of the ribbon cartridge.
Semiautomatic Paper Loading
Nov 93
Once the printer's tractors have been set up for the specific paper being used
and power has been applied, the semiautomatic paper loading feature may
be used.
After the paper is loaded in the lower tractors, pressing the FORM
FEED
pushbutton causes the paper to move up at a slower rate (10 inches per
second) to the top tractors.
NOTE: Some extremely thin forms, stiff card.stock, forms with raised labels, or
envelopes with
cu.touts
may not work with this feature.
lf
you experience
problems, load the paper manually.
With the print gap adjustment wheel in the LOAD position, the paper
thickness lever at position 1, and the upper tractor doors open, complete the
following steps:
1. Load the paper into the lower tractors.
2. Press the FORM FEED pushbutton to move the paper up through the
printer to the upper tractors.
3. Load the paper onto the upper tractors and close the tractor doors.
Unlock and adjust the upper tractors as needed.
Chapter I. Getting the Printer Up and Running
1-13
Advertisement
Table of Contents
