Epson WF-C5790 Service Manual page 386

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a
Inksystem Unit
Hook
Upper Cap FFC Cover
4. Disengage hook, then remove the Upper Cap FFC Cover.
Route the FFC through the slit on the Upper Cap FFC Cover.
5. Disconnect the FFC from the Pump Encoder Sensor.
6. Release the FFC from the three tabs on the Inksystem Unit.
Disassembly/assembly
Pump Encoder Sensor
FFC
Slit
Upper Cap FFC Cover
FFC
Tabs
No. Screw Type
S4 C.B.P-TITE-SCREW-3x10-F.ZN-3C
Disassembly/Reassembly Procedures
Inksystem Unit
Acetate tape
Wasted Ink Tube
Inksystem Unit
No. Screw Type
S4 C.B.P-TITE-SCREW-3x10-F.ZN-3C
7. Peel off a piece of acetate tape.
8. Remove the four screws (S4: ), and remove the Inksystem Unit.
 Route the Wasted Ink Tube through the guide on the Inksystem Unit.
 Route the pump motor cable through the slit on the Inksystem Unit.
Revision A
Inksystem Unit
Guide
Slit
Pump motor cable
386
Confidential