5. In order to protect sensitive microprocessors and circuitry, use static discharge equipment, such as anti-static wrist straps, when accessing internal components.

6. Do not tilt this product immediately after initial ink charge, especially after performing the ink charge several times. Doing so may cause ink to leak from the

product because it may take some time for the waste ink pads to completely absorb ink wasted due to the ink charge.

7. Never touch the ink or wasted ink with bare hands. If ink comes into contact with your skin, wash it off with soap and water immediately. If you have a skin

irritation, consult a doctor immediately.

8. When disassembling or assembling this product, make sure to wear gloves to avoid injuries from metal parts with sharp edges.

9. Use only recommended tools for disassembling, assembling or adjusting the printer.

10. Observe the specified torque when tightening screws.

11. Be extremely careful not to scratch or contaminate the following parts.



Nozzle plate of the print head



Gears



Rollers



LCD



Scanner Sensor



Exterior parts

12. Never use oil or grease other than those specified in this manual. Use of different types of oil or grease may damage the component or give bad influence on the

printer function.

13. Apply the specified amount of grease described in this manual.

14. Make the specified adjustments when you disassemble the printer.

15. When cleaning this product, follow the procedure described in this manual.

16. When transporting the product with ink filled in the print head, take precautionary measure against ink leak before packing the product.

17. Make sure to install antivirus software in the computers used for the service support activities.

18. Keep the virus pattern file of antivirus software up-to-date.

Confidential

Table of Contents