Epson WF-C5790 Service Manual page 364

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a
A8 B8 C8
D8 E8
Tab
FFC
Double-sided tape
When disconnecting the FFC, make sure to unlock the connector lock beforehand.
C H E C K
P O I N T
1. Disconnect the FFC from the connector (CN42) on the Main Board Assy.
2. Peel off the FFC from the Frame Base.
3. Release the FFC from two tabs on the Frame Base.
Set the ferrite core of the FFC in the point shown above.
Disassembly/assembly
Panel Assy
Close
Open
Ferrite core
Main Board
Assy
CN42
Connector lock
Disassembly/Reassembly Procedures
Panel Assy
Bearing Shaft
4. Remove the two screws (S4: ), then remove the Right Panel Holder.
5. Release the shaft of the Panel Assy from bearing, then remove the Panel Assy.
Revision A
Right Panel Holder
Panel Assy
No. Screw Type
S4
C.B.P-TITE-SCREW-3x10-F.ZN-3C
Confidential
364