Epson WF-C5790 Service Manual page 365

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a
B9 C9
D9 E9
Panel Housing
Hooks
1. Remove the six screws (S4: ) that secure the Panel Housing.
2. Disengage three hooks on the Panel Housing, and remove the Panel Housing.
3. Remove the Panel FFC Cover.
Install the Panel FFC Cover as shown above.
4. Pull the Relay Cable out from the hole of the Panel Housing.
Disassembly/assembly
Panel Housing
Panel FFC Cover Cover
NG
OK
Hole Panel FFC Cover
Relay Cable Hook
No. Screw Type
S4 C.B.P-TITE-SCREW-3x10-F.ZN-3C
Disassembly/Reassembly Procedures
B10
Numpad Board Assy
Relay Cable
Relay Cable Cover
1. Peel off the Relay Cable Cover, and disconnect the FFC from the connector (CN311) on the
Panel Board.
2. Remove the screw (S4: ), and remove the Relay Cable Cover.
3. Remove the four screws (S4: ), and remove the Numpad Board Assy.
Revision A
Numpad Board Assy
Panel Board
Double-sided tape CN311
No. Screw Type
S4
C.B.P-TITE-SCREW-3x10-F.ZN-3C
S4 C.B.P-TITE-SCREW-3x10-F.ZN-3C
Confidential
365