EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a
Step
Check the status of the PF Encoder and FFC
Check the PF Encoder to make sure that it is not damaged, and there is no
4
disconnection or contact failure in the FFC.
Check the status of the PF Scale.
5
Is the PF Scale dirty or damaged?
Replace the Main Board Assy.
6
Does the error occur after replacing the Main Board Assy?
Troubleshooting
Check and measure
Troubleshooting procedure
Yes
Go to step 5
Go to step 6
Replace the Printer Mechanism.
Revision A
No
Replace the PF Encoder Board if parts are
damaged.
Properly connect the FFC.
Replace the Printer Mechanism if the FFC is
damaged.
Clean, if dirty.
Replace the PF Scale, if damaged.
End
Confidential
108