Epson WF-C5790 Service Manual page 203

EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a
No. Parameter Name
100 REDUCT/CUTOUT SEND
101 V.29 EP TONE
102 1ST DIS IGNORE
103 RTC (EOL x12)
104 ---
105 ---
106 ---
107 ---
108 ---
109 ---
110 COMM MONITOR
Troubleshooting
Table 4-6. FAX Service Parameter Table
Setting Range Initial value
Reduction Send
CutOut Send LEFT
Reduction Send
CutOut Send CENTER
CutOut Send Right
On
Off
Off
On
Off
Off
On
Off
Off
Until Detect
Until Detect
Always
Fax Troubleshooting
Unit
Process setting when the transmission document width differs from the
recording width of the receiver at the time of transmission
 Reduction Send = Reduction and sending
 CutOut Send LEFT = Cut the Left end, and sending on original size.
 CutOut Send CENTER = Cut the both end, and sending on original size.
 CutOut Send Right = Cut the Right end, and sending on original size.
When sending V.29 9600 / 7200 bps, add an echo suppressor tone.
It is used when a communication error has occurred due to the influence of
line echo of overseas communication.
Ignore the first DIS at the time of transmission and receive from the second
DIS.
Select RTC signal [EOL × 6 / EOL × 12] at the end of the PIX signal
(switch from high speed to low speed)
 Until Detect
The monitor turns on when sending out and turns off when it detects a
facsimile signal.
 Always
The monitor is always on.
Since it is possible to listen to the signal at fax communication from the
monitor speaker, it is used at the time of investigation of image defect
trouble.
After troubleshooting confirmation, remember to return to original.
Revision A
Remark
203
Confidential