Extron electronics NAV E 511 User Manual page 37

Screen Saver pane
This pane shows the options for the screen saver on the LOOP THRU port (see
page 6) and streamed outputs. If you change any setting, either directly or by clicking RESET
(see figure 21, ), the SAVE button (
6
CANCEL ( ) to abandon the changes. Clicking either button closes the dialog box.
5
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
Figure 21. Screen Saver Configuration Pane
Screen Saver Mute — Click to toggle the Screen Saver Mute on (muted) and off
1
(unmuted) for the Loop Thru (see
sets whether the screen immediately enters low power mode (screen saver is muted)
upon loss of sync or displays the user-entered background image (see Background
Image, ) for a period of time set by the Screen Saver Duration setting,
4
NOTE: Allow Audio Only (see
disabled to use a screen saver.
Screen Saver Duration (available when Screen Saver Mute is Enabled
2
[ ]) — Click in the Duration field and edit it as desired or click
1
increment or decrement the delay (in seconds) of how long the screen
saver stays active and streaming, before muting sync to a display. The valid
range is from 1 to 500 (seconds) or 501 Always on.
When Screen Saver Mute is unchecked (
Always on.
After the duration expires, the encoder drops the active sync, allowing the monitor to
turn off or enter low power mode.
) becomes selectable. Click SAVE to take change or
4
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
on page 6) and streamed outputs. This control
B
Allow Audio only,
), the duration automatically becomes 501
2
NAV E 511 Encoder • HTML Operation
on
B
.
3
, on page 27) must be
4
or to
29