Table of Contents
Advertisement
Operation
This section of the manual discusses the operation of a DSC 301 HD device, and is
divided into the following sections:
•
•
•
Front Panel Overview
A
CONFIG
CONFIG
Extron
Extron
B
Figure 3.
A
B
C
D
E
F
Front Panel Overview
DSC 301 HD Menu System — Configuration and Adjustments
Front Panel Lockout (Executive Modes)
1
2
3
1
2
3
C
DSC 301 HD Front Panel Features
Status LED (power and signal) — This LED lights amber when power is present
but no signal is detected, and green when power and signal are both present.
USB mini-B configuration port — Connect a computer to this USB mini-B port for
device configuration, control, and firmware upgrades.
Input selection buttons and LEDs (1-3) —
•
Input LEDs — The LED of the selected input lights when the button is pressed.
Input 1 (composite video input button) — Input 1 selects the composite video
•
input.
Input 2 (configurable input button) — Input 2 selects the RGB (RGBHV,
•
RGBS) or YUV (YUV-HD, YUVp, YUVi) input.
•
Input 3 (HDMI/DVI button) — Input 3 selects the HDMI or DVI input signal.
HDCP content LEDs — These LEDs indicate HDCP status for inputs and output
•
Light green when the input or connected display is HDCP encrypted.
•
Remain unlit when the current input or HDMI output is not HDCP encrypted.
•
Blink amber when the video output has been disabled (such as when in sync
mute or screen saver mode).
Menu Navigation buttons (Menu and Enter) —
Menu — Press this button to access and move through the OSD menu system.
•
•
Enter — Press this button to step through the OSD submenus (see the
DSC 301 HD OSD Menu System — Configuration and Adjustments
on the next page).
Adjustment knobs (horizontal [ and vertical {) — When using the menu
system, rotate either of these two knobs to scroll through the menu options and to
make any adjustments.
D
HDCP
HDCP
INPUT
INPUT
OUTPUT
OUTPUT
MENU
ENTER
MENU
ENTER
E
DSC 301 HD • Operation
ADJUST
ADJUST
DSC 301 HD
DSC 301 HD
F
section
8
Advertisement
Table of Contents
