Advertisement
NAV SD 511 • Setup Guide (Continued)
F
LAN LEDs
(see
figure 2
•
NAV LED —
Link LED — Lit steadily indicates that a network link is established at 1G.
•
•
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
•
Ext LED —
•
Link LED — Lit steadily indicates that a network link is established at 1G. Blinking indicates a link speed less than 1Gbps.
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
•
G
ID button and LED
paired to a NAV encoder (see
Operation
Power
When power is applied, the decoder runs a series of self-tests that blink the front panel Power LED and all other indicators. The decoder
then boots the NAV operating system. It can take approximately 45 seconds for self-test and system startup to complete. When the
process is complete, the Power LED lights steadily.
decoder
NOTE:
The
System Operation
The decoder can be configured and controlled using embedded web pages or Extron Toolbelt (see the NAV SD 511 User Guide available
www.extron.com
at
and the Toolbelt Help file).
The
NOTE:
"Connection via web pages,"
NOT be necessary if your system includes a NAVigator System Manager
Connection via web pages
Connection to the decoder and its embedded web pages can be made via either the front panel Configuration (USB) port (using IP over
USB technology) (see figure 2,
Access the decoder using HTML pages as follows:
Start a web browser.
1.
NOTES:
•
Suggested browsers to fully support the NAV system are: Google Chrome™, Mozilla Firefox™, and Microsoft
•
The network must be properly configured for multicasting (IGMP). Failure to do so may result in degraded performance.
Enter the IP address of the decoder in the browser Address field.
2.
NOTES:
•
Default settings:
Port
Config (USB)*
NAV 1G (Fiber)
•
If you use IP over USB, Extron recommends waiting a minute after plugging in the cable for your PC to identify the USB
connection as a valid Ethernet port.
on page 2) — Indicate the status of the network connections, as follows:
— The recessed ID button identifies the decoder when pressed. The LED blinks three times when the decoder is
Pairing devices via front panel
is NOT operational until the boot process is complete (the Power LED is lit steadily)
Connection
A
on page 2) or the rear panel NAV 1G port (see figure 1,
DHCP
IP address
203.0.113.22
On
on page 5).
settings, and
Pairing devices via front panel
.
* For the Config port, the address for IP over USB
CANNOT be changed.
Subnet mask
If the unit does not receive a DHCP address,
a self-assigned Link Local Address, is assigned in
the range 169.254.X.X.
.
procedures (see page 5) may
A
on page 1).
®
Edge™.
3
Advertisement
