Extron electronics NAV E 511 User Manual page 34

Loop Thru pane
If you change any of the settings in the Loop Thru Configuration dialog box (see
), the SAVE button (
figure 18, through
1 5
changes or CANCEL ( ) to abandon them. Clicking either button closes the dialog box.
7
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
Figure 18. Loop Thru Pane
HDCP Mode — Click the drop-down list to select between
1
the following two output modes for the LOOP THRU port (see
on page 6).
B
• — Mimics the HDCP encryption state of the
Follow Input
connected source.
• — Maintains the HDCP encrypted state
Alway Encrypt
with the output sink device to improve system switching
performance.
Video Output — Click the drop-down list to select among
2
the various output formats and colorspace for the LOOP THRU
port ( ). The table below shows the available formats.
B
Format
Auto (based on the EDID of the sink
[default])
DVI RGB 444
HDMI RGB 444 Full
HDMI RGB 444 Limited
Color Bit Depth — Click the drop-down list to select
3
between the following two output formats for the LOOP THRU
port ( ).
B
• Auto — Adjusts color bit depth based on the display EDID
(10 bit or 8 bit) (default).
• Force 8-Bit — Always uses 8 bit output.
) becomes selectable. Click SAVE to take
6
7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7
Format
HDMI YUV 444 Full
HDMI YUV 444 Limited
HDMI YUV 422 Full
HDMI YUV 422 Limited
NAV E 511 Encoder • HTML Operation 26