Advertisement
NAV 10SD 501 and NAV 10SD 101 • Setup Guide (Continued)
E
USB LEDs
(NAV 10SD 501 only, see
•
Host
Lit steadily – The decoder is in USB host mode.
•
•
Unlit – The decoder is in USB device mode, the default condition.
•
Active
•
Lit steadily – A USB device or host is connected to the rear panel USB port.
•
Unlit – No host or USB device is connected to the rear panel USB port.
Blinking – A USB device or hub is connected to the decoder and is attempting to draw more power than the USB port can
•
supply.
F
LAN
LEDs— Indicate the status of the network connections, as follows:
NAV LED (NAV 10SD 501) or LAN LED (NAV 10SD 101) —
•
•
Link LED — Lit steadily indicates that a network link is established at 10G.
•
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
Ext LED (NAV 10SD 501 only) —
•
Link LED — Lit steadily indicates that a network link is established at 1G. Blinking indicates a link speed less than 1Gbps.
•
•
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
G
ID button and LED
paired to a NAV encoder (see
Operation
Power
When power is applied, the decoder runs a series of self-tests that blink the front panel Power LED and all other indicators. The decoder
then boots the NAV operating system. It can take approximately 45 seconds for self-test and system startup to complete. When the
process is complete, the Power LED lights steadily.
NOTE
decoder
The
:
System Operation
The decoder can be configured and controlled using embedded web pages or Extron Toolbelt (see the NAV 10SD 501 and NAV 10SD 101
User Guide available at
www.extron.com
The
"Connection via web pages,"
NOTE:
NOT be necessary if your system includes a NAVigator System Manager
Connection via web pages
Connection to the decoder and its embedded web pages can be made via either the front panel Configuration (USB) port (using IP over
USB technology) (see figure 2,
Access the encoder using HTML pages as follows:
Start a web browser.
1.
:
NOTES
•
Suggested browsers to fully support the NAV system are: Google Chrome™, Mozilla Firefox™, and Microsoft
•
The network must be properly configured for multicasting (IGMP). Failure to do so may result in degraded performance.
figure 2
on page 2) — Indicates the status of the USB stream, as follows:
— The recessed ID button identifies the decoder when pressed. The LED blinks three times when the decoder is
Pairing devices via front panel
is NOT operational until the boot process is complete (the Power LED is lit steadily)
and the Toolbelt Help file).
Connection
on page 2) or the rear panel NAV 10G port (see figure 1,
A
on page 5).
settings, and
Pairing devices via front panel
.
.
procedures (see page 5) may
on page 1).
A
®
Edge™.
3
Advertisement
