Setting The Serial Port Baud Rate And Data Format; Setting The Serial Port Access Permission - evertz 8083XDS-AD Instruction Manual

>PORT A BAUD
BaudA=1200
BaudA=2400
BaudA=4800
BaudA=9600
BaudA=19200
BaudA=38400
>PORT A WORD
WordA 7 odd
WordA 7 even
WordA 8 none
WordA 8 odd
WordA 8 even
>PORT A MAP
A:CF1234 TF1234X
OPERATION
8083XDS-AD Analog and SD-SDI XDS Encoder
3.3.1

Setting the Serial Port Baud Rate and Data Format

Two menu items are used to set up the serial port connection parameters.
There is a pair of menu items for each of the ports. A third menu item sets
the port permissions for each port.
PORT A BAUD is used to set the baud rate of the communications
port A (similar menu items are available to configure the baud
rates for ports B and C). Adjust this setting to match the baud
rate of your computer. If unsure what to set the baud rate to,
set it to 1200 baud (the factory default setting).
PORT A WORD is used to select the number of data bits and parity of
the communications port A. (similar menu items are available to
configure the data format for ports B and C).
Select WordA 7 odd for 7 data bits, 1 stop bit odd parity.
Select WordA 7 even for 7 data bits, 1 stop bit even parity.
Select WordA 8 none for 8 data bits, 1 stop bit no parity.
Select WordA 8 odd for 8 data bits, 1 stop bit odd parity.
Select WordA 8 even for 8 data bits, 1 stop bit even parity.
3.3.2

Setting the Serial Port Access Permission

PORT A MAP is used to permit port A to control the various data streams
(similar menu items are available to configure permissions for
ports B and C).
permissions.
The two digits to the right of the 'CF' indicates whether port A
can control the caption streams in the respective field. The two
digits to the right of the 'TF' indicates whether port A can control
the test streams in the respective field.
indicates whether port A can control extended data services
('X'). A dash character in place of the numeral indicates that
field is not permitted for port A. For example if CF1---TF----X
is displayed, port A can only control the caption streams from
field 1 (CC1 and CC2) and the Extended Data Services but not
the caption streams from field 2 (CC3 and CC4) or any of the
text streams.
Revision 1.0.2
See section 4.7 for a discussion of port
The rightmost digit
Page 3-13