Table of Contents
Advertisement
Chapter 3 Printing
<Setting Example>
The following describes how to configure the
settings when printing by dividing copies by the
number of employees per division.
General
Division
Affairs
No. of
employees
Necessary
number of
copies
Divide groups into division units and specify the
numbers in [Copies] and [Sets] respectively for
each group. Enter the number of employees in
[Copies]. To print one set of copies specified, enter
1 in [Sets].
Division
Group
General
Affairs
Accounting
Management
In addition, when multiple groups have the same
necessary number of copies, you can group them
together as one group by increasing the number of
sets. In this case, both the general affairs and
management divisions have the same number of
copies, so that you can configure the settings as
follows to print by dividing copies by corporate
division.
Division
Group
General
Affairs,
Management
Accounting
„
Sort
Specify whether to print page by page or in sets.
[Uncollated], [Collated]
„
Slip Sheet (Program)
Insert a slip sheet to separate printouts into
specified units.
126
Accounting Management
10
6
10
6
Printer Driver Settings
Copies
01G
10
02G
6
03G
10
Printer Driver Settings
Copies
01G
10
02G
6
[OFF]
Slip sheets are not inserted.
[Between Sets]
Slip sheets are inserted between sets.
[Between Groups]
Slip sheets are inserted between groups.
10
„
Slip Sheet Tray
[Standard Tray], [Feed Tray 1], [Feed Tray 2],
10
[Feed Tray 3], [Additional Tray]
^
^
•
When using the optional high capacity feeder,
[High Capacity Feeder] is displayed in place of
[Standard Tray].
•
[Additional Tray] is displayed when using the
optional additional tray.
„
Number on Slip Sheet
Sets
When this check box is selected, numbers are
1
stamped on the slip sheets.
If [Between Sets] is selected, the group number
1
and set number are stamped.
1
If [Between Groups] is selected, the group number
is stamped.
„
Offset Output (Program)
If you are using the optional face down finisher,
high capacity stacker, or multifunction finisher, you
can configure this item. For more information, see
the following:
•
When using the face down finisher (p.183
"Offset Output (Program)")
•
When using the high capacity stacker (p.202
Sets
"Offset Output (Program)")
•
When using the multifunction finisher (p.214
2
"Offset Output (Program)")
1
^
^
Slow Printing
You can slow down the printing speed. This also
reduces the amount of noise produced by the
machine when printing jobs.
^
^
Blank Page Detection
The print data is printed excluding the blank pages.
ComColor GL Series User's Guide
Advertisement
Table of Contents
