Installation and mounting
5.5 Setting up the charging station
5.5.5
Installing the cable management
5.5.5.1
Installing the mounting plates
The following operating instruction shows how to install the mounting plates of the cable
management of the charging station.
If you install the cable management system afterwards, make sure that the system is
completely isolated from the power supply.
Do not pull on the rope of the rope box
Do not pull on the rope of the rope box because the spring force can cause injuries or
damage to the cable management due to the rope stopping mechanism.
1. Screw in one nipple each
③
Figure 5-10 Example: Bezel bracket right
2. Place a square washer
left and right DC charging points on the charging station.
Figure 5-11 Placing the mounting plates
86
WARNING
and the bezel bracket on the left. The tightening torque is 3 Nm.
①
②
with an M4 hexagon nut
②
on each M12 thread
①
to the bezel bracket on the right
. Place the two mounting plates for the
Operating Instructions, 11/2023, A5E50556539-AG
SICHARGE D