Installing The Cover - Siemens SICHARGE D Product Information

Installing the cable management

Installing the cover

The following operating instruction shows how to install the cover of the charging station.
1. Place the cover on the charging station.
Figure 15 Placing the cover
2. Screw in the cover with the ten M6x16 hexagon socket-head screws.
–
Allen size is 4 mm
–
The tightening torque is 3 Nm
Figure 16 Screwing down the cover
To install the filter bezel, proceed in the reverse order to removal as described in section "Removing the roof (Page 80)".
3.
Click the filter bezel on the back of the charging station into the nipples of the bezel bracket on the left and bezel bracket on the
right.
Swivel the filter bezel downward. Also click the filter bezel into the nipple of the charging station.
4.
First, thread the door in at the bottom again. Press the upper part of the door against the cabinet on the left side. Turn the twist
5.
levers outwards and lock the door.
88
Installation of the cable management system
A5E53160522-AA, 11/2023