Error Message "Charging Station Out Of Service - Siemens SICHARGE D Operating Instructions Manual

Error messages and remedy

8.2 Error message "Charging station out of service"

8.2 Error message "Charging station out of service"
The controller of the charging station automatically detects any critical fault. If the error
affects the entire charging station, it is put out of service. The operator is informed via a
message to the OCPP backend that support from Siemens Service is required. This service can
first analyze the problem remotely via the SCB. This message contains additional information
about the exact cause of the error. The touch screen shows the following error message.
The display shows the error message "Out of order" in full screen mode. The charging station
cannot be operated in this state.
Figure 8-2 Error message "The charging station is currently out of order"
NOTE
This error message is also displayed if the Emergency Stop was triggered by a dispenser or
the external load management system.
End error state
Using the information sent to the SCB, the service personnel on site can localize and correct
the fault.
120
Operating Instructions, 11/2023, A5E50556539-AG
SICHARGE D