Dispenser - Siemens SICHARGE D Operating Instructions Manual
Hide thumbs
Also See for SICHARGE D:
- Product information (93 pages) ,
- Operating instructions manual (32 pages) ,
- Commissioning manual (30 pages)
Table of Contents
Advertisement
5.6.3
Dispenser
If a dispenser is to be connected to the charging station, you must connect the DC cables to
the corresponding busbars on the back of the device. Use the fastening material pre-mounted
on the connection bars of the charging station. Also connect the required conductors for
auxiliary power supply (230 V AC), communication and integration into the controller of the
charging station. The connections for these cables are located on the device panel on the
front.
Connections for the DC cable
①
②
③
④
⑤
Figure 5-34 Connections for the dispenser cable
Preparing conductors
1. Select an M10-size cable lug for the corresponding conductor cross-section.
2. Shorten the conductors to the final length.
3. Strip the insulation from the end of the conductor so that the remaining insulation
extends up to the cable lug.
4. Slide a shrink-on sleeve over the wire.
5. Fasten the cable lug correctly to the end of the conductor.
6. Pull the shrink-on sleeve over the joint and heat it up.
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
Dispenser B +
Dispenser A +
Dispenser B –
Dispenser A –
PE
Installation and mounting
5.6 Connecting the charging station
103
Advertisement
Table of Contents
