Stopping The Charging Process - Siemens SICHARGE D Operating Instructions Manual

Operation

7.4 Stopping the charging process

7.4 Stopping the charging process
Automatic stopping
The following scenarios result in automatic termination of the charging process:
• Vehicle ends charging process regularly
• Vehicle detects a fault
• Charging station detects an internal critical error
• Emergency stop is triggered by actuation of the emergency stop switch, opening of the
device doors, interruption of the external safety loop or by the external load management
system
Manual stopping
To stop the charging process manually, you must be logged in. Switch to the detail view of
your charging process. You can end the charging process by pressing the "Stop charging"
button on the bottom right. You will be asked if you want to end the charging process.
Confirm by tapping the button on the bottom right again. Following this, the summary of the
charging process appears.
Figure 7-5 Stopping the charging process
Depending on the setting in the SCB, the user must authenticate again for confirmation. All
instructions are displayed on the touch screen. After successful completion, the display
changes again and the user receives summarized information about the charging process.
This information again depends on the selected charging port and the available tariff
information.
After completion of the charging process, insert the charging plug into the corresponding
holder.
116
Operating Instructions, 11/2023, A5E50556539-AG
SICHARGE D