5.5.8
Installing baseboards
Mount the baseboards as follows:
1. Start with the rear baseboard. Use two M6 Allen screws (5 mm Allen wrench) to screw the
rail to the rear device support feet.
2. The two lateral baseboards are inserted into the rear baseboard and then fixed to the two
front device support feet with M6 Allen screws.
3. The front baseboard is also plugged in and additionally screwed in from above with the
front door open.
Disassembly is only possible in reverse order.
Figure 5-28 Baseboard assembly
5.6
Connecting the charging station
5.6.1
Safety instructions
The installer is responsible for the electrical connection of the charging station. Connect the
charging station in accordance with the relevant regulations (for conductor cross-section,
fuses, ground connection).
For all work on the charging station, observe the safety instructions (Page 13), the
requirements of DIN EN 50110‑1:2013 for safe working with and on electrical installations or
equivalent applicable local guidelines.
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
Installation and mounting
5.6 Connecting the charging station
97