Siemens SICHARGE D Operating Instructions Manual page 104

Installation and mounting
5.6 Connecting the charging station
Connecting the conductors
1. Insert the connection bolt through the screw holes of the cable lug and copper bar.
2. Fasten the conductors according to Figure 5-15 with an M10 fastening nut and a
tightening torque of 40 Nm.
3. Mark the tightened connections, for example, with a red paint stick.
Auxiliary power supply
The SICHARGE D charging station can supply the associated dispensers with the required
230 V operating voltage via a secure auxiliary power supply.
Connections for the auxiliary power supply
Figure 5-35 Connections for the auxiliary power supply
Connect the conductors for Dispenser 1 via -FC2 and Dispenser 2 (not used) via -FC3 as
follows:
• -XD35:1 for N (-FC2)
• -XD35:2 for L (-FC2)
• -XD35:3 for N (-FC3) (not used)
• -XD35:4 for L (-FC3) (not used)
The maximum conductor cross-section is 4 mm². The connections are intended exclusively for
supplying dispensers. These circuits are not protected against residual currents, e.g. by a
residual current circuit breaker.
104
Operating Instructions, 11/2023, A5E50556539-AG
SICHARGE D