Positioning The Charging Station - Siemens SICHARGE D Operating Instructions Manual

Dispenser cable
If a dispenser is to be connected to the charging station, proceed as follows:
1. Shorten the cables to a length that allows you to easily introduce them into the charging
station, recommendation: 60 cm measured from the top edge of the foundation. Observe
the exact position of the cable entry for the DC cables on the rear of the charging station.
2. Remove the sheath of the DC cables.
3. Protect the individual conductors properly from environmental influences such as dirt and
moisture.
In addition to the power connections, the dispenser requires an auxiliary power supply,
communication cables and integration into the controller of the charging station. Lay these
cables separately from the power cables. Ensure proper protection of the cables from
environmental effects such as dirt and moisture.
Observe the operating instructions of the dispenser.
5.5.2

Positioning the charging station

To set up the charging station at the location, you need to lift the charging station from the
transport carrier using either a crane or a forklift (see section 4 "Transport and storage" (Page
63)). Then transport the charging station to the prepared base area. Lifting and positioning
with a crane is recommended.
Lifting the charging station from the transport carrier
Suspended load
A falling charging station or parts can cause death or serious injury. Stay completely away
from any hazardous areas.
1. Open the device door, remove the cable gland plate below the connection bars on the
circuit breaker and close the door.
2. Repeat this step on the back of the device if you want to connect dispensers to the
charging station.
3. Procedure with crane or forklift
– Using a crane (recommended):
– Using a forklift:
4. Loosen the screws between the charging station and transport carrier.
5. Lift the charging station vertically.
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
DANGER
Attach the eyebolts to the four corners of the roof of the cabinet frame (see figure 4-2
in section General information (Page 63)). When using your own eyebolts, ensure that
they have an M12 thread that is 25 to 30 mm long and are suitable for the weight of
the charging station. Then hang the hoist
Drive the forks from the front or from behind under the bottom of the cabinet until the
forks protrude on the other side. Pay attention to the center of gravity of the device.
Installation and mounting
5.5 Setting up the charging station
83