Interface Commands; Chapter 49 Interface Commands; Overview; Interface Command Examples - ZyXEL Communications MS-7206 User Manual

C
H A P T E R
These are some commonly used configuration commands that belong to the
port-channel

49.1 Overview

The

interface port-channel

port basis.

49.2 Interface Command Examples

This section provides examples of some frequently used interface commands.
49.2.1 interface port-channel
Use this command to enable the specified ports for configuration. Indicate multiple, non-
sequential ports separated by a comma. Use a dash to specify a port range.
Syntax:
interface port-channel <port-list>
An example is shown next.
• Enter the configuration mode.
• Enable ports 1, 3, 4 and 5 in slot 4 for configuration.
• Begin configuring for those ports.
sysname# config
sysname(config)# interface port-channel 4/1,4/3-4/5
sysname(config-interface)#

49.2.2 bpdu-control

Syntax:
bpdu-control <peer|tunnel|discard|network>
MS-7206 User's Guide

Interface Commands

group of commands.
commands allow you to configure the switch on a port by
49
interface
303