Configuring Snmp; Setting Up Login Accounts; Figure 57 Access Control: Snmp; Table 40 Access Control: Snmp - ZyXEL Communications GS-3012F User Manual

Table 39 SNMP Traps (continued)
OBJECT LABEL
authenticationFailure 1.3.6.1.6.3.1.1.5.5
RFC 1493 Traps
newRoot
topology change

17.3.3 Configuring SNMP

From the Access Control screen, display the SNMP screen. You can click Access Control to
go back to the Access Control screen.

Figure 57 Access Control: SNMP

The following table describes the labels in this screen.

Table 40 Access Control: SNMP

LABEL
Get Community Enter the get community, which is the password for the incoming Get- and GetNext-
Set Community Enter the set community, which is the password for incoming Set- requests from the
Trap
Community
Trap
Destination
Apply
Cancel

17.3.4 Setting Up Login Accounts

Up to five people (one administrator and four non-administrators) may access the switch via
web configurator at any one time.
Chapter 17 Access Control
OBJECT ID
1.3.6.1.2.1.17.0.1
1.3.6.1.2.1.17.0.2
DESCRIPTION
requests from the management station.
management station.
Enter the trap community, which is the password sent with each trap to the SNMP
manager.
Enter the IP addresses of up to four stations to send your SNMP traps to.
Click Apply to save your changes back to the switch.
Click Cancel to begin configuring this screen afresh.
GS-3012/GS-3012F User's Guide
DESCRIPTION
This trap is sent when an SNMP request comes from non-
authenticated hosts.
This trap is sent when the STP root switch changes.
This trap is sent when the STP topology changes.
108