Pin Assignment, Device Plug; Preparing The Measuring Device; Connecting The Measuring Device - Endress+Hauser Proline Cubemass C 100 Operating Instructions Manual

Proline Cubemass C 100 Ethernet/IP
Endress+Hauser
7.2.4

Pin assignment, device plug

Supply voltage
Pin
2
1
2
1
3
3
5
4
4
5
A0016809
Coding
Device plug for signal transmission (device side)
Pin
2
1
2
1 3
3
4
4
Coding
A0016812
7.2.5

Preparing the measuring device

NOTICE
Insufficient sealing of the housing!
Operational reliability of the measuring device could be compromised.
‣
Use suitable cable glands corresponding to the degree of protection.
1. Remove dummy plug if present.
2. If the measuring device is supplied without cable glands:
Provide suitable cable gland for corresponding connecting cable.
3. If the measuring device is supplied with cable glands:
Observe requirements for connecting cables →  27.
7.3

Connecting the measuring device

NOTICE
Limitation of electrical safety due to incorrect connection!
‣
Have electrical connection work carried out by appropriately trained specialists only.
‣
Observe applicable federal/national installation codes and regulations.
‣
Comply with local workplace safety regulations.
‣
Always connect the protective ground cable  before connecting additional cables.
‣
For use in potentially explosive atmospheres, observe the information in the device-
specific Ex documentation.
‣
The power unit must be tested to ensure it meets safety requirements (e.g. PELV,
SELV).
L+
L-
A
+
+
-
-
D
Electrical connection
Assignment
DC 24 V
Not assigned
Not assigned
DC 24 V
Grounding/shielding
Plug/socket
Plug
Assignment
Tx
Rx
Tx
Rx
Plug/socket
Socket
29