Protecting Settings From Unauthorized; Access; Write Protection Via Access Code - Endress+Hauser Proline Cubemass C 100 Operating Instructions Manual

Proline Cubemass C 100 Ethernet/IP
Parameter
Assign simulation process variable
Value process variable
Simulation device alarm
Diagnostic event category
Simulation diagnostic event
* Visibility depends on order options or device settings
Endress+Hauser
Parameter overview with brief description
Prerequisite
–
A process variable is selected
in the Assign simulation
process variable parameter
(→  69).
–
–
–
10.7 Protecting settings from unauthorized access
The following options exist for protecting the configuration of the measuring device from
unintentional modification after commissioning:
• Write protection via access code for Web browser →  69
• Write protection via write protection switch →  70
10.7.1

Write protection via access code

With the customer-specific access code, access to the measuring device via the Web
browser is protected, as are the parameters for the measuring device configuration.
Navigation
"Setup" menu → Advanced setup → Administration → Define access code
‣
Administration
Define access code
Device reset
Defining the access code via the Web browser
1. Navigate to the Define access code parameter.
Description
Select a process variable for
the simulation process that is
activated.
Enter the simulation value for
the selected process variable.
Switch the device alarm on and
off.
Select a diagnostic event
category.
Select a diagnostic event for
the simulation process that is
activated.
Commissioning
Selection / User Factory setting
entry
• Off Off
• Mass flow
• Volume flow
• Corrected volume
flow
• Density
• Reference density
• Temperature
*
• Concentration
*
• Target mass flow
*
• Carrier mass flow
Depends on the 0
process variable
selected
• Off Off
• On
• Sensor Process
• Electronics
• Configuration
• Process
• Off Off
• Diagnostic event
picklist (depends
on the category
selected)
→  68
→  92
69