Energy Saving; Description; Energy Savings Programming; Programming Of Group Stand-By - Wega Concept Use And Maintenance Manual

Wegaconcept
16

Energy Saving

16.1

Description

A series of technical innovations allows a substantial
reduction in energy consumption.
• reduction of heat loss through insulation of the boil-
ers;
• distribution of power among the groups based on
operation via electronic control;
• possibility to program reduced consumption or night-
time shutdown of the machine;
• self-learning of daytime working routine
• possibility to program the operating temperature of
the groups and boiler.
16.2

Energy savings programming

To achieve substantial energy savings, you can
activate the Energy Saving function when the machine
is not in use, for example at night.
In this phase the machine is not turned off , but is
placed at a lower temperature (programmable).
To program the machine's energy saving function,
refer to chapter "23 Programming".
16.3

Programming of group stand-by

The system lets you achieve further energy savings
setting two or more periods, during the days of operation,
when the functions of one or more delivery groups are
reduced (stand-by).
The confi guration of these periods can be carried out
in two ways:
• manual programming: setting of stand-by start and
end time of the delivery groups involved only in 2
periods;
• self-learning: the system, during the fi rst week of
work, monitors the use of the machine and then au-
tomatically processes and sets the times and groups
involved in the stand-by (only if enabled as shown in
chapter 23 Programming);
To program the stand-by of the groups, please refer
to chapter "23 Programming".
28
17

Group washing

If provided for in the programming, the machine
automatically requests that the washing of the delivery
groups be carried out.
Attention: during this phase, all the coff ee selections
are disabled until the washing has been completed.
Follow the indications provided on the display:
• Use the solid
fi lter;
• insert the de-
tergent tab
into the fi lter;
• attach filter
holder to delivery group 1;
PROG/STOP" key to start the washing
• press the "
phase;
the following messages appear on the display in
alternating sequence:
GR.1 WASHING ON
GR.2 ADD DETERGENT
GR.3 ADD DETERGENT
GR.4 ADD DETERGENT
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
Cycle start
5" 5" 5"
5" 5"
5" 5" 5"
5" 5"
• wait for the washing to be carried out until the fol-
lowing messages appear on the display:
GR.1 REMOVE FILTER
GR.2 ADD DETERGENT
GR.3 ADD DETERGENT
GR.1 STOP/PROG KEY
GR.4 ADD DETERGENT
GR.2 STOP/PROG KEY
GR.3 STOP/PROG KEY
GR.4 STOP/PROG KEY
GROUP WASHING
PUT THE DETERGENT
THEN PRESS
STOP/PROG KEY.
GR.1 WASHING ON
Cycle end
5"
5"
Group
solenoid valve
5"
5"
Pump
Technical manual