Table of Contents
Advertisement
•
Decreasing the value of the skew rotates the horizontal lines counterclockwise. The left end of the
line remains in the same place and the right end moves upward.
3
Select OK.
4
Print a Quick test page to verify the change.
5
Repeat steps 1 to 4 until the horizontal line is properly aligned with the leading edge of the page.
6
Check for proper margin alignment. See
Adjusting the margins
To check for proper margin alignment:
1
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Registration adjust
2
Select Quick Test, and then press OK or touch Start.
The printer prints a test page.
3
Check the top and bottom margins of the test page for proper alignment.
To adjust the margins:
1
Refer to the test page, and then check the arrows along the margins.
Notes:
•
The arrows should be completely visible along the edges.
•
The tip of the arrows should point to the edges of the paper.
2
Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Registration adjust
3
Select the field of the margin to adjust.
4
Specify value. The value range is from -80 to 80.
Notes:
•
For 2‑line LCD screens, use the left or right arrow buttons to increase or decrease the value.
•
Raising the value of the top margin setting pushes the top edge of the image downward.
•
Raising the value of the bottom margin setting pushes the bottom edge of the image upward.
•
Raising the value of the left margin setting pushes the left margin to the right.
•
Raising the value of the right margin setting pushes the right margin to the left.
"Adjusting the margins" on page
Parts removal
301
301.
5028
Advertisement
Table of Contents
