Table of Contents
Advertisement
3
Adjust the printhead until the bottom left corner of the printhead touches the alignment pin (A).
4
Print another test page, and then check if the printhead is aligned.
5
Repeat steps 4 and 5 until the printhead is aligned.
6
Tighten the three screws.
Registration adjustment
Image misalignments can occur after printhead replacement. Perform this procedure to correct the position of
the image relative to the paper edges.
Note: You cannot perform mechanical registration or skew adjustments on this printhead.
Before performing the procedure, make sure that the tray guides are properly set and the paper settings on
the printer match the paper size loaded in the tray.
A
Parts removal
299
5028
Advertisement
Table of Contents
