Removing a Slimline Optical Drive
1. Disconnect the SATA power from system power supply and SATA cable connector
from server board.
2. Press the optical latch and slide the optical drive assembly out of the chassis.
3. Install slimline drive bay filler blank, if no optical drive installed.
Installing and Removing the PCI Riser Assembly
Removing the PCI Riser Assembly
1. Disconnect any cables attached to any add-in cards.
2. Grasp the riser assembly and pull up to release it from the system.
Figure 31. Removing the PCI Riser Assembly from the Server System
Installing the PCI Riser Assembly
1. Lower the riser assembly into place (see letter "A").
2. Align the two hooks in the riser assembly with the matching slots at the back of the
server system (see letter "B").
®
Intel
Server System SR1695WB Service Guide
AF003463
41