Reset; Power Consideration - Kontron VX3030 User Manual

VX3030 User's Guide
7.6

Reset

Reset and SW1 Reset Switch
The VX3030-RTM generates a system reset signal on the VPX bus at each +5V power-on for a duration of 140
ms to 560 ms.
In addition, the front panel reset push button of the VX3030-RTM is used to generate a VPX bus reset with the
same minimum duration.
LEDs
The five LEDs are not connected, and unused.
7.7

Power Consideration

Only the 5V main power from the VPX is used.
The 3.3V and +12V VPX main power are not used in order to accomodate 3U VPX backplane.
Auxiliary VPX voltages 3.3V (I2C connector), +/- 12V (PIM J10 connector) are used.
The 3.3V on the J10 connector is regulated from the 5V input through a 1.5A max linear regulators.
CA.DT.A87-5e
Reset Push Button
Figure 46: VX3030-RTM Reset Push Button
VX3030-RTM Characteristics
Page 73