System Memory Support; Emmc Flash Memory; Wifi/Bluetooth 1216; Table 7: Memory Options - Kontron SMARC-sAMX8 User Manual

5.2. System Memory Support

The system supports the following memory features:

LPDDR4 @ 1600 MHz (no ECC)

Table 7: Memory Options

Processor type
QuadPlus, QuadMax

5.3. eMMC Flash Memory

An optional embedded Multimedia Flash Card (eMMC) complying with the eMMC 5.1 specification can be permanently
attached to the module, allowing for a capacity of up to 64 GByte NAND Flash.
Specific eMMC Flash memory features are:
 Up to 64 GByte

eMMC 5.1 specification
 Class 0 (basic); class 2 (block read); class 4 (block write); class 5 (erase); class 6 (write protection); class 7 (lock
card)
 HS200/HS400 modes
 DDR modes up to 52 MHz clock speed
 ECC and block management
 Boot operation (High-speed boot)

Sleep mode
 Permanent and power-on write protection

Replay-protected memory block (RPMB)
 Secure erase and secure trim

5.4. WIFI/Bluetooth 1216

WIFI/Bluetooth 1216 option may be install onboard. Allow to connect SMARC-sAMX8 to WIFI and Bluetooth network.
If module installed, following features might be unavailable:
-SD card onboard is unavailable if a module with SDIO interface is used
-USB5 on SMARC Connector is unavailable if a module with USB interface is used
-PCIe B is unavailable if a module with PCIe interface is used
-SER2 on SMARC Connector is unavailable if a module with a serial interface is used
www.kontron.com
RAM
LPDDR4 (no ECC)
up to 8GB
Kontron SMARC-sAMX8 - Rev. 1.2
// 26