Table of Contents
Advertisement
VX3030 User's Guide
2.5
Initial Installation Procedures
The following procedures are applicable only for the initial installation of the VX3030 in a system. Procedures
for standard removal operations are found in their respective chapters.
To perform an initial installation of the VX3030 in a system proceed as follows:
1. Ensure that the safety requirements indicated in Section 2.1 are observed.
Failure to comply with the instruction below may cause damage to the board or result in improper system
operation.
2. Ensure that the board is properly configured for operation in accordance with application requirements before
installing. For information regarding the configuration of the VX3030 refer to Chapter 5. For the installation of
VX3030 specific peripheral devices and Rear I/O devices refer to the appropriate sections in current Chapter.
Care must be taken when applying the procedures below to ensure that neither the VX3030 nor other
system boards are physically damaged by the application of these procedures.
3. To install the VX3030 perform the following:
1. Ensure that no power is applied to the system before proceeding.
When performing the next step, DO NOT push the board into the backplane connectors. Use the ejector
handles to seat the board into the backplane connectors.
2. Carefully insert the board into the slot designated by the application requirements for the board until it
makes contact with the backplane connectors.
3. Using the ejector handle, engage the board with the backplane. When the ejector handle is locked, the
board is engaged.
4. Fasten the front panel retaining screws.
5. Connect all external interfacing cables to the board as required.
6. Ensure that the board and all required interfacing cables are properly secured.
The VX3030 is now ready for operation. For operation of the VX3030, refer to appropriate VX3030 specific
software, application, and system documentation.
CA.DT.A87-5e
Installation
Page 23
Advertisement
Table of Contents
