Table of Contents
Advertisement
VX3030-RTM Characteristics
7.8
Rear I/O Interfaces
The VX3030 Rear Transition Module conducts a wide range of I/O signals through the Rear I/O connectors RP0,
RP1 and RP2.
> RP0:
one 15-wafer 7-row connector
> RP1:
one 16-wafer 7-row connector
> RP2:
one 8-wafer 7-row connector
To support the Rear I/O feature a special backplane is necessary. Do not plug a Rear I/O configured
board in a non-system slot Rear I/O backplane. Failure to comply with the above may result in damage to
your board.
2
The VX3030-RTM provides the following interfaces:
> Two USB 2.0 ports (USB2 and USB3 via RP1 connector)
> One Gigabit Ethernet port without LED signals (ETH via RP1 connector)
> Two SATA ports (SATA0 and SATA3 via RP1 connector)
> Two EIA-232 COM ports (COM1 via RP1 connector, COM1 via RP2 connector)
Page 74
RP0
16
1
Figure 47: Rear I/O VPX Connectors
RP1
RP2
16
1
VX3030 User's Guide
8
CA.DT.A87-5e
Advertisement
Table of Contents
