Safety And Regulatory Information; Compliances And Safety Statements - SMC Networks WAP3110-L Quick Start Manual

S afet y and R egulator y I nformati on
IEEE 802.11b/g/n Enterprise Access Point
WAP3110-L

Compliances and Safety Statements

FCC Class B
This document provides information on switch safety, regulatory statements and
compliances. It includes these sections:
◆
"Compliances and Safety Statements" on page 7
◆
"Warnings and Cautionary Messages" on page 12
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
◆
Reorient or relocate the receiving antenna
◆
Increase the separation between the equipment and receiver
◆
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
◆
Consult the dealer or an experienced radio/TV technician for help
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
– 7 –
Quick Start Guide