3
Remove the flat-blade screwdriver to clamp the wire.
2.5mm
Note To disconnect, pull out the wire with the shaded (
er.
Selecting Input Control Logic
By factory default, the multifunction input terminals are set to sink logic (NPN).
To change the input control logic to source logic (PNP), switch SW1 to the SOURCE side.
Multifunction Input Terminals and Programmable Controller Con-
nection
Sink logic
M1 Series EtherCAT Type User's Manual (I670)
Push in the shaded
portion with a
flat-blade screwdriver.
+24
DI1 to DI7
DIC
Output unit
Insert the wire.
) portion pushed in with a flat-blade screwdriv-
Sink
Source
Photocoupler
Inverter
2 Design
Remove the
flat-blade screwdriver
2
to clamp the wire.
2-61