Installation; Mounting The Netpa Ultra Series Amplifiers; Tabletop Use - Extron electronics NetPA Ultra Series User Manual
2-channel and 4-channel dsp and dante-enabled power amplifiers
Hide thumbs
Also See for NetPA Ultra Series:
- User manual (118 pages) ,
- Setup manual (8 pages) ,
- User manual (116 pages)
Table of Contents
Advertisement
Installation
This section describes the installation and setup of the NetPA Ultra Series of power
amplifiers. Topics include:
•
•
•
•
Mounting the NetPA Ultra Series Amplifiers
The NetPA Ultra Series amplifiers can be mounted in a rack using the included rack ears,
mounted on a rack shelf, set on a table or mounted in the plenum space above a ceiling-
mounted projector. Also, two amplifiers can be connected using the bridging plate to create
a full rack-width unit.
This guide uses images of the NetPA U 1004 to describe installation, but all the amplifiers
are installed the same way.
Tabletop Use
Four self-adhesive rubber feet are included. Attach one foot at each corner on the bottom
side of the amplifier and place the unit in a desired location.
Mounting the NetPA Ultra Series Amplifiers
Rack Mounting
Rack Mounting Ventilation Recommendations
Flexible Conduit Adapter Kit
NetPA Ultra Series • Installation
4
Advertisement
Table of Contents
Troubleshooting
