Extron electronics NetPA Ultra Series User Manual page 98

Command SIS Command
Function (Host to Device)
Standby Commands
Disable standby
E
NOTE: Turns off standby mode.
Enable auto standby
E
(Default)
NOTE: The amplifier enters auto power save mode if there is no active signal for 25 minutes. Whenever this command is sent, the standby timer
restarts and the amplifier goes into power save state.
Force standby on
E
Unit goes into standby and stays in standby until PSAV is set to another mode.
NOTE:
Query standby power
E
mode, power save state
Verbose mode 2/3
NOTES:
•
When the amplifier is first powered up, the amplifier will be in Psav1*1.
•
Unsolicited responses will be sent out when the unit goes into or out of standby mode.
•
Line outputs are disabled when in standby mode.
•
Standby power mode should be set to '0' if this amplifier is to be used as an off-ramp.
•
Standby Priority: The standby contact closure port has the highest priority and supersedes SIS and the timer.
SIS is the next highest priority and supersedes the timer.
The timer has the lowest priority and can be overruled by contact closure and/or SIS.
KEY:
X12!
= SIS Standby power mode
X12@
= Power save state
NOTE: Unsolicited responses will be sent out when the unit goes into or out of standby mode.
Response
(Device to Host)
}
0PSAV Psav
}
1PSAV Psav
}
2PSAV Psav
} X12!
PSAV
0
= auto standby timer disabled
1
= (Default) auto standby timer running, but not triggered
0
= unit is active and auto standby timer disabled
1
= (Default) auto standby timer running, but not triggered)
4
= standby triggered (contact closure triggered
NOTE: When the standby contact closure is shorted, the unit goes into mode 4 and cannot come
out of mode 4 until the port is no longer shorted. Once the short is removed the unit returns to its
last known standby mode and the timer resets.
X12!]
X12!]
X12!]
X12@]
*
NetPA Ultra Series • Remote Control and Configuration
Additional Description
X12! X12@]
Psav *
2
= standby triggered (SIS triggered)
2
= standby triggered (SIS triggered)
3
= standby triggered (timer triggered)
91