Extron electronics NetPA Ultra Series User Manual page 7

Dante Controller ...................................... 75
Overview ........................................................... 75
Downloading and Installing Dante Controller ...... 76
Configuring a NetPA Ultra Series Amplifier in
Dante Controller ............................................... 76
Device Name ................................................. 76
Receiver and Transmitter Names ................... 77
Dante Controller Naming Conventions ........... 77
Renaming the NetPA Ultra Series Amplifier
in Dante Controller ........................................ 77
Renaming a Receiver or Transmitter............... 79
Finding a Dante Device IP Address ................ 80
Dante Controller Operation ................................ 81
Dante Transmitters and Receivers .................. 81
NetPA Ultra Series Transmitters and
Receivers...................................................... 81
Dante Routing Operation ............................... 81
Routing Devices............................................. 81
Disconnecting Inputs from Outputs ................ 82
Dante Troubleshooting ....................................... 83
Simplifying the Network for Troubleshooting... 83
Troubleshooting the Network Interface ........... 83
Restarting Dante Controller ............................ 84
Remote Control and Configuration
Connection Options ........................................... 85
RS-232 Port .................................................. 85
AT Port .......................................................... 86
USB Config Port ............................................ 86
Verbose Modes ............................................. 86
Host-to-Device Communications ....................... 87
NetPA Ultra Series-initiated Messages ........... 87
Using the Command and Response Tables ....... 87
Error Responses ............................................ 88
Symbol Definitions ......................................... 88
Command and Response Table ......................... 89
Input Path OIDs (NetPA U 1004) .................... 99
Input Path OIDs (NetPA U 1002) .................... 99
Output Path OIDs (NetPA U 1004) ............... 100
Output Path OIDs (NetPA U 1002) ............... 100
Mix-point OIDs............................................. 100
Troubleshooting
Amplifier Fails to Exit Standby Mode
Promptly ......................................................... 101
Amplifier Enters Standby Mode Too Early ..... 101
Limiter/Protect LED Warning Indicators........ 102
Over Temp Indicator LED ............................. 102
Status Commands ....................................... 102
.......... 85
..................................... 101
Contents
NetPA Ultra Series •
vii