To Configure The Break In Smb Port (All Processors); Break In Smb Port Behavior - Agilent Technologies E5900B User Manual

To configure the Break In SMB port
(All processors)
If you have an emulation probe, but you do not have an emulation module, use
the following table to configure the behavior of the Break In SMB connector
on the front of the emulation probe.
When the emulation probe is connected to an emulation module via the
module/probe interconnect cable, this configuration item is always set to rising
for compatibility with intermodule triggering.
If you need to break on a falling edge, either trigger from the logic analysis
system or use the emulation probe without the emulation module.
Break In Configuration
Command
cf breakin=rising
cf breakin=falling
cf breakin=off
There is a delay of about 400 µ sec between receiving the edge and stopping
the processor.
Agilent Technologies Emulation for the PowerPC 400/600/700
Chapter 7: Configuring the Emulation Probe
Emulation probe Break In
The emulation probe will cause a break into monitor on a
rising edge. (Default)
The emulation probe will cause a break into monitor on a
falling edge.
Inputs to Break In will be ignored.
Configuration items
97