Step 5: Check Your Debugger Connection; If You Have Problems Using The Emulation Probe With A Debugger - Agilent Technologies E5900B User Manual

analysis system you must have installed an E5901B emulation module and you
must connect the emulation probe to the emulation module using the module/
probe interconnect cable. In addition, the emulation probe must be connected
to the logic analysis system using a LAN.
• Check that the emulation probe and the logic analysis system are on
the LAN.
If you are using a site LAN you should be able to ping both the logic analysis
system and the emulation probe.
If you are using a point-to-point LAN connection you must use a special
crossover LAN cable, such as the one supplied with the emulation module.
The telnet window of the logic analysis system should be able to communicate
with the emulation probe. This window can be found by selecting the System
Admin icon in the main system window.
• Check that the emulation probe is connected to the emulation module
with the module/probe interconnect cable.
If this cable is connected, you should be able to display the firmware version
from the Update Firmware window.
• Check that you have the proper processor support package installed.
You can check this by selecting the System Admin icon in the main system
window, then looking at the list of software packages installed.
• Test the emulation module. See page 176.
• Test the emulation probe. See page 177.
• Try using the Setup Assistant to configure your measurement setup.

Step 5: Check your debugger connection

If you are using a debugger, try connecting to the emulation probe.
If you have problems using the emulation probe
with a debugger
Most problems are associated with not having the emulation probe and target
Agilent Technologies Emulation for the PowerPC 400/600/700
Chapter 12: Troubleshooting the Emulation Probe
Troubleshooting Guide
153