Using The Cf Commands - Agilent Technologies E5900B User Manual

Chapter 7: Configuring the Emulation Probe

Using the cf Commands

Using the cf Commands
You can configure the emulation probe using the built-in "cf" commands.
1 Establish communications with the emulation probe over the LAN.
You can either telnet from a networked computer or you can use the
debugger. For more information, refer to "Connecting the Emulation Probe to
a Site LAN" on page 40.
Debuggers typically provide some way to enter commands in the emulation
probe's command line interface, or they provide a window for configuring the
emulation probe.
2 Enter the "cf" command to view the current configuration settings.
Example
p>cf
cf rrt=yes
cf reset=runrom
cf speed=26MHz
cf mrdop=mm
cf dmwrop=mm
cf imwrop=upd_dcu
cf mrddel=0
cf mwrdel=0
cf breakin=rising
cf trigout=monhigh
cf parity=off
cf address=effective
cf 32bitmode=off
cf vref=external
cf thresh=1/2
72 Agilent Technologies Emulation for the PowerPC 400/600/700